Try YouTube! When the washer does spin, its spins fine, however about 50% of the time it doesn't spin at all. When the spin cycle starts but doesn't spin, the water drains fine and the pump operates. or end. It is still doing that every few loads - skipping the spin cycle, leaving my clothes soaked. If I wait several hours and then put on drain spin cycle it works. I have a 10 year old maytag epic Z front load washer.model mhwz400tq02.The wash cycle always works correctly.the rinse cycle sometimes stops at the beginning and sometimes at the end, the spin cycle also stops at the beg. Helpful. I've done a fair amount of investigating and research and have found the following. If missing or damaged, the washer will not agitate or spin… It just starts to ramp up then stops and the drain pump comes on for a second but if I remove the vibration sensor from the tub during the times it’s trying to spin up, it will work normally. Unbalanced clothes will also cause a washer to shudder or “walk.” Open the lid and reposition the clothes.

The machine performs fine until the final spin cycle. The washer motor has 4 blinking green lights. If your washer seems to complete all of its cycles but won’t spin: 1 Check to see if the clothes have jammed or are unbalanced in the drum. Hi, our maytag front load sometimes doesn’t spin other times it does, it stops spinning on the 1st load, 2nd or on the 3rd, it can be at min 5, 8, 7 not always is the same, and then turn off or display “End”. Washer Won’t Spin. At times, it does the final spin just fine; I estimate about 50/50. Dusty. on Aug 12, 2016. Type in 'ge washer won't spin'. Will probably end up calling a repairman.

When it won’t spin it doesn’t spin at all in that cycle, but when it will spin it goes fine and spin … Would this also make it skip spin cycles at times? I have a Samsung wf56h9100 front load washer and during both the rinse and spin cycles, the washer won’t spin up to remove the water from the clothes. Most models have either a lid switch probe or a magnet on the lid that activates the lid switch when the lid is closed. I am beginning to think its possessed. Reply.

When agitating, the basket moves inside the tub and the tub moves side to side a bit. I have a model WBSR3140DAWW GE washing machine.

The washer agitates properly at all times, so I ruled out the motor coupler. Sometimes, the washer will pump out the rinse water and just sit until the timer expires without performing a final spin. It works good sometimes and then other times it won't drain or spin. A worn clutch can prevent your washing machine from spinning or may cause a slower spin speed which will leave your clothes wet after a cycle. Additional symptoms that the clutch may be causing your problems are brake dust or shavings found underneath the washing machine, a slight burning smell or a loud noise during the spin cycle. The washer will not agitate or spin with the lid up, though many models will still fill and drain and the timer will advance. I watched videos on youtube and saw this is a bad mode shifter.